T-Shirt Forums banner

Is There a Forum Like This for Engraving?

1254 Views 3 Replies 3 Participants Last post by  hi-nrg-joe
I just purchased a Roland EGX-350 engraver at the ISS Show in Ft. Worth that I will be getting this week. I plan to make some rhinestone transfers, but I believe that more profitable things can be done using this for engraving manufacturing nameplates, signs, etc.

Does anyone here know of a forum similar to this one where one can post for help, get ideas, etc?
1 - 4 of 4 Posts
You may try signing up for the Roland User Forums, as there was a link to them on the Roland Desktop Engravers Resource site. :)
Thanks, I signed up and am awaiting approval. I couldn't figure out how to access the forum to just read posts without having to register.
Hi Gail,

I have an engraver, but I think it's quite different than the one you have. The forum I use for engraving, woodworking, etc is www.sawmillcreek.org

Here is the direct link to the engraver's section. Engravers Forum - Sawmill Creek

The people there are very friendly and helpful, just like the ones here. Hope you can find what you're looking.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top