I am trying the Inneo Royal for lights with my Xerox copier, the images print out beautifully, bright and very sharp!!
I am pressing on a lightweight 100% polyester flag blank, but the recommended time/temp 400 for 30 seconds was too hot for the poly.
I am wondering what the lowest temp would be that might work? I did test on a poly t-shirt with no problem, but the flag is so much thinner, and I don't have any sample flag material to play with.
I tried just repressing the flag material at about 365... and yes, I did use a teflon cover, but it still seems too hot, when I lift the press, the flag material seems to shrink a little as well as stiffen a bit, so I think it is too close to melting still.
Has anyone used this Inneo paper?
I am pressing on a lightweight 100% polyester flag blank, but the recommended time/temp 400 for 30 seconds was too hot for the poly.
I am wondering what the lowest temp would be that might work? I did test on a poly t-shirt with no problem, but the flag is so much thinner, and I don't have any sample flag material to play with.
I tried just repressing the flag material at about 365... and yes, I did use a teflon cover, but it still seems too hot, when I lift the press, the flag material seems to shrink a little as well as stiffen a bit, so I think it is too close to melting still.
Has anyone used this Inneo paper?
