[civil238]

[media]http://i.imgur.com/3WbWZNI.jpg[/media]

Im not sure if i should wash the shirt first but im guessing it a problem with either too thick ink on shirt or curing. i use a heat gun for a while some part are very well like thin words but these huge circles like cracking.
I have no way to tell temp. Idk what to do.

Thans in advance guys!

 

[ole Jobe]

The cracking is definitely a sign of undercuring. The heat gun CAN work but it is an iffy situation. God Bless.

 

[2020 PrintWorks]

Is there a local screen print shop that would let you run your shirts through the dryer for a small fee?

 

[civil238]

Is there a local screen print shop that would let you run your shirts through the dryer for a small fee?

I have no idea. and at this point ive spent so much money so i dont want to do that. my first batch where really expensive and im bearly making any profit but from these i will make triple so i dont plan on wasting anymore money.

i found a temp gun on amazon for 20 is that a viable solution i keep reading 320 degrees is normal

 

[2020 PrintWorks]

I usually try to stick between 320 and 340. I've never tried curing with a heat gun. I'd post a thread asking for advice from people who have. Or try searching the forum. Maybe there's a trick to it. The thing is if there's any part of the print that you didn't get to 320 then that part it is going to wash out.

 

[civil238]

I usually try to stick between 320 and 340. I've never tried curing with a heat gun. I'd post a thread asking for advice from people who have. Or try searching the forum. Maybe there's a trick to it. The thing is if there's any part of the print that you didn't get to 320 then that part it is going to wash out.

Thannk you will do!