T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
61 Posts
Discussion Starter · #1 ·
Hey guys!
I am using an F2000. White Level 2 and color level 3.
My prints are looking great! However, I made myself a shirt and I have wore it probably 3 or 4 times. Most of the print still looks really good but(I'm a girl! haha) right in the middle of my chest I'm getting vertical cracks. It's like the ink is pulling apart with a lot of little cracks. It is a fitted shirt but it's not very tight. Is there anything I can do to fix this? I plan on listing quite a few mom shirts like "football mom" basketball mom" etc etc. But, I'm afraid they will also have this issue. Is the only fix to sell unisex(loose) shirts? Is this maybe a pretreat or cure issue? Like I said, the rest of the design still looks as good as the day I printed it.

I cure at 120-150 seconds at 375. I pretreat enough that I don't get those white "flecks" in my color ink.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.