T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
26 Posts
Discussion Starter · #1 ·
The largest print I can obtain from my printer (Epson 1430) is a 13" x 19". I need to print to a 14" 18" aluminum substrate. I have a 16x20 heat press. Does anyone have any creative thoughts or past experience for doing a cut and paste to increase that 1 inch gap from 13" to 14" without leaving an obvious paste line on the print??

Most appreciate any and all suggestions and advice.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top