[BiM Custom Gear]

Hi,

Just got my Image Clip Laser Light paper samples and I have to say the results are really good, but in some cases the polymer background even though it's supposed to be self-weeding seems to be left behind on the tshirt after pressing. After pressing 2 sheets together and transferring the artwork onto the green sheet there are bits of polymer left behind on the red sheet. Can anyone please advise if this is just a case of adjusting the pressure or something else should be done in order to get the polymer completely of the red sheet and subsequently not appearing on the tshirt.

Thanks,

 

[JSISIGNSCOM]

what temp do you have it set at? It should be 220 for 20 seconds heavy pressure. Peel while hot and you should have a white film over the image.