T-Shirt Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi,

Just got my Image Clip Laser Light paper samples and I have to say the results are really good, but in some cases the polymer background even though it's supposed to be self-weeding seems to be left behind on the tshirt after pressing. After pressing 2 sheets together and transferring the artwork onto the green sheet there are bits of polymer left behind on the red sheet. Can anyone please advise if this is just a case of adjusting the pressure or something else should be done in order to get the polymer completely of the red sheet and subsequently not appearing on the tshirt.

Thanks,
 

·
Registered
Joined
·
261 Posts
no problem. been working with them myself in the last few days. i really do like neenah papers products. so far the ones ive tested are outstanding. They just have a little bit of a learning curve.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top