T-Shirt Forums banner
Cancel

HTV on water resistant poly

3216 Views 4 Replies 3 Participants Last post by  Lnfortun, 
1
so ive got a buddy that wants me to put his race car number on a "name brand" 100% polyester Contour Softshell jacket. it also has the Omni-Shield water and stain repellent...

this will be my first poly press and im looking for advice so i dont ruin his expensive jacket and want it to have a good finish and feel. i need some vinyl, temp and pressure advise and any other advise about what im going to be doing :D thanks

heres what ill be putting on im guessing the back of the jacket im guessing(havent asked yet just got the pic)

Attachments

Reply
Save
Like
1 - 5 of 5 Posts
splathead
3 colors on the Columbia jacket? How expensive are they?

If it were me, I would pass for the following reasons: 1. Multiple color vinyl has major registration issues due to shrinkage from the heat press. 2. Coated fabric can cause issues with vinyl and printing staying stuck. 3. I would feel obligated to replace the jacket if something goes wrong and I'm not prepared to do that.
Reply
Save
Like
  • Like
Reactions: 1
1
splathead said:
3 colors on the Columbia jacket? How expensive are they?

If it were me, I would pass for the following reasons: 1. Multiple color vinyl has major registration issues due to shrinkage from the heat press. 2. Coated fabric can cause issues with vinyl and printing staying stuck. 3. I would feel obligated to replace the jacket if something goes wrong and I'm not prepared to do that.
Click to expand...
these are my concerns exactly..especially if i ruin the jacket...
Reply
Save
Like
1
concerns aside, can it be done? and if so advice on how to best go about it...
Reply
Save
Like
Lnfortun
1ArmBandit said:
concerns aside, can it be done? and if so advice on how to best go about it...
Click to expand...
Water repellant may prevent the HTV adhesive to adhere on the fabric. Try pressing a small piece somewhere hidden like under the arm by the armpit. Check if it will not come off. You can remove it with 100% acetone. Do not use nail polish remover. It leaves trace on the fabric. If it does not adhere try wiping the area with acetone then press a small piece.
Reply
Save
Like
  • Like
Reactions: 1
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
T-Shirt Forums
A forum community dedicated to T-shirt merchants, professionals and enthusiasts. Come join the discussion about graphics, commerce, dyes, prints, collections, guides, displays, styles, scales, equipment, accessories, reviews, classifieds, and more!
Full Forum Listing
Explore Our Forums
Screen Printing General T-Shirt Selling Discussion Graphics and Design Help Member Introductions Heat Press and Heat Transfers
Top