T-Shirt Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I think my emulsion may have kicked the bucket but I'm not 100% sure. I have Ulano QX-1 and I'm exposing with a 1000watt Metal Halide about 18 in. away. I put the lid down and turned on the vacuum blanket and 10min. later I only had a 1 or maybe a 2 on the Stouffer strip. Just got a new bulb in the MH ballast and I wasn't sure if the Emulsion was bad or maybe the ballast is only working partially.
So, what are the symptoms of a bad emulsion? Does it just stop exposing properly or what?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top