T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 · (Edited)
I bought this press used. Someone has painted it and I do not see a name anywhere on it.
It was in pieces and I have tried to put it together a few ways but it doesn't seem right. I have cleaned out all bearings with brake cleaner and re greased them.

I have a bearing and a large washer left. I do not know where the bearing goes? Should i place it under the rotary arm or under the printing arms?

I have attached a drawing I made up, if a visual helps.

any one familiar with this setup that can give me some input, I would be grateful.

[URL="
[/URL]


I have tried several times to post this pic, It will not work.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top