T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
23 Posts
Discussion Starter · #1 ·
Hey guys, I have a question; I am trying to avoid as many chemicals etc as possible due to in-house printing; I was thinking it might be possible to use magnets to hold down transfer sheets.

I am trying to avoid TAC spray, i was thinking maybe i could put magnets UNDER the platen and on top to hold down the transfer down while printing, however the only downside is that would get Hot when drying; What other solutions do you guys have that might hold down a transfer conventionally

-Thanks :D
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.