Hello t-shirt forums,
I have a couple HM-1's, one that has been malfunctioning since one of my staff did a head replacement. My employee did manage to break one of the sensors on the left side of machine ( near the mother board) but I was able to super glue it back into place and it seems to be functioning correctly. Currently the machine receives a job when I send it over, The solid light shows up and everything seems normal and good to go. Then when I load the printer it goes through its pre-print routine and then eventually gives me the double blinking lights, fatal error.
I used the diagnostic tool to find out what this error was.
Fatal Error: FB
PF Motor Drive Error.
Does anyone know what could be causing this? Any help would be greatly appreciated. Thanks in advance!
Anthony
I have a couple HM-1's, one that has been malfunctioning since one of my staff did a head replacement. My employee did manage to break one of the sensors on the left side of machine ( near the mother board) but I was able to super glue it back into place and it seems to be functioning correctly. Currently the machine receives a job when I send it over, The solid light shows up and everything seems normal and good to go. Then when I load the printer it goes through its pre-print routine and then eventually gives me the double blinking lights, fatal error.
I used the diagnostic tool to find out what this error was.
Fatal Error: FB
PF Motor Drive Error.
Does anyone know what could be causing this? Any help would be greatly appreciated. Thanks in advance!
Anthony
