T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi all,
I am new to heat transfer printing and recently purchased a used Hix N-800. I just replaced the air regulator and the adjustment knob appears to be leaking air. I've tried 2 different, new regulators and both appear to be leaking. Is this normal? The press works fine and the pressure seems to hold based on the gauge but I can definitely hear air leaking from the knob. Any advice is greatly appreciated. Thanks!
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Thanks for your reply. Yes, I wrapped all the threads with teflon tape. It seems as though the air is leaking from the adjustment knob and not from any of the hoses. Is there a place to tighten on the adjustment knob other than the ring that attaches the regulator to the machine?
did you wrap the threads with teflon tape? This could help the air not leak out. .... JB
 
1 - 3 of 3 Posts
Top