T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
55 Posts
Discussion Starter #1
I usually go with 45 dpi, doing a process print and want to go smaller halftone. I´m limited to just 230 screens so I was wondering if I could go up to a 50 and the mesh still hold it. 230/4.5 is 51.1. Just want to know if any of you have used that dpi on the 230 mesh???

Thanks!
Raul
 

·
Registered
Joined
·
924 Posts
I have gone as high as 55 dpi. Dot gain gets pretty tuff but I have burned it successfully on a 200 mesh. Normally I use a 305 mesh for such high detail.
 
1 - 3 of 3 Posts
Top