T-Shirt Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi! :) I just started using an Epson C88+ inkjet printer to print transfers. I have a new press that uses celius. So here's my problem, I heat the press to 190c which is 375 degrees, then I use strong pressure for 25-30 seconds. When I peel back the paper most of the transfer has adhered, but some small areas have not "melted". I am using transfer paper for white cloth. on a white 50-50 blend shirt, and I peel the backing off immediately. What am I doing wrong?:(
 

·
Registered
Joined
·
449 Posts
hi yankeesfan4vr,

i do not know what the recommended temp is but your process seems fine.

you may now have to tweak your process a little by trial and error...
try a little hotter, more pressure or longer down time.

are there any buttons, zippers, or places close to a seam where the press might not be hitting evenly?

good luck yanks...
 
1 - 2 of 2 Posts
Top