T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hi There everybody.
I'm new to the T-Shirt bussiness.
I received my Rabbit plotter/cutter with Artcut two days ago and haven't taken it out of the box yet, so any advice from anybody with experience with these machines will be appreciated.
Actually any advice with regard to cutting vinyl/thermal transfers will be good.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.