T-Shirt Forums banner

Help with first run....

1K views 3 replies 2 participants last post by  TerriFontenot 
The lpi depends on the mesh count. Take the mesh count and divide it by 4.5 and then divide the mesh by 5 to get an acceptable lip starting point range. We can work that in reverse by multiplying the lpi by 4.5 and by 5. For a lpi of 35 that would put you in the range of 157 to 175 on the mesh count so a 160 would be a good mesh to use for 35 lpi.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top