T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
2 Posts
Discussion Starter · #1 ·

Can anyone help,

I am using my Neoflex printer and after printing on all 3 plattens instead of going in to print end mode it stays in printing mode..

With the front screen on the table saying **Print Mode** ** Printing** and on the printer it says ready

sometimes the printer moves back to the front of the neoflex and sometimes it says at the back with same problem

This has only just started to happen and is becoming very annoying as i have to press start twice and then go through the non genuine set up again on the printer.

Thanks and appreciate any help

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.