T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
209 Posts
Discussion Starter · #1 ·
Hi Guys,

Normally I would not bother you all with a stupid thing like this, BUT this time I am stumped. My Roland kicked the bucket and I rushed out and got a Creation Kingcut PRO II from ebay, link below

★★★ Creation Kingcut PRO II 730mm Quality Vinyl Cutter Cutting Machine NS ★★★ | eBay

So I am running windows 7 64 bit with USB connection and do you think I can get it loaded on my computer after a week at it......NO!!!

The CD that came with it showed a virus on the CD so I canned it. Went to website and downloaded the drivers and they came up with a virus or adware also so scraped them. Got a clean copy and went to install, gets half way in and crashes. Try running in previous version of windows thru windows 7 and it crashes. USB to Serial port comes up and it is assigned to a COM port.

Read all the post on here and I mean ALL OF THEM. So I downloaded a few software choices mentioned in previous posts, signcut and setup using every single one of the creation models and nothing or crashes. Downloaded signtools 4 and it software goes to open and it says bootstrap has stopped working and crashes without loading.

Any help greatly appreciated or a point in the right direction.

Cheers Daniel
 

· Registered
Joined
·
4 Posts
I finally got this machine going, what a bloody nightmare!!

No help from the supplier, other than to question whether I even know how to use a computer, turned out the idiots didnt even send me everything you need to run it. I have an xp computer and its now working, but be careful with this company, they dont seem legit at all
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top