T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hello everyone this is my first Epson 1400 DTG printer I purchased this printer about a week ago. Last night finally cut out the plastic base and the lower rear brace and starter up and came up with two red lights, paper feed and CD tray open. I have not built the base yet but with the videos you guys posted really helpful, hopefully I should be there within another week. I will post some pictures of where I'm at now with my project. Can anyone point me in the right direction for a rip software that will run on my Mac? Thanks to everybody in advance!!!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top