T-Shirt Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
499 Posts
Discussion Starter · #1 ·
Is it possible to transfer a heat press cad cut vinyl onto a mousepad? I have seen some mouse pads that appear to have a "cloth" surface. If so, where would you get the blank mousepads? Or do they have to be done via sublimation print or some other method?
 

·
Registered
Joined
·
8,081 Posts
you could print on the mouse pads...probably best place to get blanks is from a dye sub source...but I am not sure that is a good way to go because the vinyl is ontop of the pad..not part of it and running the mouse over it would be noticeable...
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top