T-Shirt Forums banner

Heat pressing black ink

720 Views 1 Reply 2 Participants Last post by  splathead
So every now and then it seems that when pressing ink jet or dye sub transfers (I think laser too but been awhile) blacks seem to either be muted or mottled.
I normally make sure that in the design that the black is RGB 0 0 0.
I am wondering if d using like CMYK 50 50 25 100 (rich black) on those large black areas or bold text might be better. Anyone use Rich Black for their designs that are heat pressed ?
1 - 2 of 2 Posts
I'd just give it a test press on a scrap and see.
  • Like
Reactions: 1
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.