T-Shirt Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
I have been making mugs via a mug heat press and decided to jump in and get a flat heat press.
It arrived today with some ouse mats for me to tinker with.
The question is, should it take about 7 - 10 minutes to warm up to 180-200 degrees? My mug press is much faster, but a lot smaller.

I made a couple of mouse mats but they took around 10 mins plus to work - a couple I took out too early didn't print properly.

I assumed that to do a mouse mat I would switch on the timer for 60-90 seconds put the press down it wouyld heat up very, very fast and ding ding my mat done in 60 seconds - Is this wrong is that only for the mugs?

Thanks for any advice as i'm a newbie here

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.