T-Shirt Forums banner
1 - 6 of 6 Posts

· Registered
Joined
·
21 Posts
Discussion Starter · #1 ·
After a bit of research I know I'd at least need the bar clamp adapters. My press doesn't have side clamps. Will I be able to use these screens or should I look into finding someone to trade for smaller, square bar roller screens? Would really like to make the move from static to roller. Any advice is appreciated.
 

· Registered
Joined
·
326 Posts
Unfortuantely no, you most likely will not be able to use newman screens on that press. There will not be a way to clamp it down, as most Newman frames I've seen are round on all sides. Also, these screens weigh as much as 2-3 regular aluminum frames and even on our Chameleon we have trouble keeping them from flopping down, and they barely fit on the press when loaded on multiple heads.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top