T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I just bought a GX-24 Roland, running it off Flexisign pro. Not sure why but when i change the settings on the cutter for the pressure and speed, it changes back when I send from my computer. Its as if the software settings over rides the cutter settings. Any help with this would be beyond appreciated. TIA
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.