T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
158 Posts
Discussion Starter · #1 ·
I am making some transfers using JPSS and I select the cut and print option in Cut Studio. The software places the registration marks and a box. I go through the cutter setup and select 11x17 and fit my design in the cut studio cut area.

After printing I put the JPSS in the cutter and select piece and the cutter makes its measurements. These measurments come back with like 7.8 x 9"

I am waisting alot of material not being able to get something setup correctly.

Anyone had this issue? Im sure I am not doing something right.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.