T-Shirt Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello Everyone,

I'm Bon, and I live in sunny Spain on the Costa del Sol. My partner runs a print a design studio here, and recently we have got hold of a used GCC Jaguar II cutter/plotter. We were looking at trying to add t-shirt design to the shops facilities, however as is often the case with seconds the kit was fine but the CD's for drivers was scratched so badly it is unreadable.
I've tried registering on the GCC site, but seem to have problems putting a European Serial number into the USA site.

If anyone has a Jaguar II, (ours is a 61) I'd really appriciate it if you could send me an ISO of your driver install CD? The JoyCut CD is fine, but the driver CD is beyond readable.

Any support anyone can offer would be greatly appriciated,

Thanks,
Bon
 

·
Registered
Joined
·
8,082 Posts
GCC does have a European office. Try contacting them at
GCC Europe B.V.
Eglantierbaan 43-45 ,
2908 LV, Capelle
aan den IJssel,
The Netherlands
Tel : +31-(0)10-4589367 begin_of_the_skype_highlighting +31-(0)10-4589367 end_of_the_skype_highlighting
Fax :+31-(0)10-4519874
[email protected]

You could also send an email inquiry to
[email protected]

this is their office in Walnut CA.

Last resort try filling out the tech support request at:
GCC LaserPro Laser Engraver, Vinyl Cutter and Printer
 
1 - 2 of 2 Posts
Top