T-Shirt Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 · (Edited)
I use Ryonet Green Galaxy water based inks. This past weekend i was doing a 3 color design (white base under the entire design, blue with opaque mixed in, black finish). The last screen was pulling up some of the blue after the flash even though it was dry to the touch. Flashed for a minute in between colors. Then after the run i washed the shirts and lost some of the color from each of the ink layers. I cured the shirts same as always - 3 minutes, temp of 340.
Any ideas what could have caused the washout or the screen lifting the color off? Kinda did everything the same as always. very odd.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top