T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
48 Posts
Discussion Starter · #1 ·
I am considering purchasing a Graphtec CE3000 M2K that has the ARMS system. Is the technology the same as the ARMS in the CE5000? Does anyone use either plotter with a Corel Plug in? What software do you recommend with this cutter and how do you like the ARMS system?
Thank you in advance for sharing your wisdom! : )

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.