T-Shirt Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
628 Posts
Discussion Starter #1
Just got it up and running.

Flexisign 8.1 is working ok but I noticed that when cutting o's or g's that the start and stop points of the cutter is wide so it ends up tearing when weeding.

Is it the cutter settings or Flexisign?

Thanks
 

·
Registered
Joined
·
628 Posts
Discussion Starter #2
Blade offset possibly?
 

·
Registered
Joined
·
996 Posts
If the text is in outline, the paths may not be connected.
 

·
Registered
Joined
·
628 Posts
Discussion Starter #4
I added .040" overcut and it eliminated the little area not cut.
Weeds much better.

But still see a bump on the outside of the letter "o" where it starts.

Is this common where the blade has to start on a radius and not a corner?
 

·
Registered
Joined
·
628 Posts
Discussion Starter #6
Yep, test from the cutter itself looks great.

I never could find the offset in this Flexi version.
 

·
Registered
Joined
·
628 Posts
Discussion Starter #7
You know since you brought it to my attention about the test cut from the cutters panel seems to be fine, then it is the software.

I finally found the offset last night and it is not checked. Guess I will continue to play with Flexi.

Im thinking I may install Adobe Illi since it will do contour cutting. Flexi dont support a Epson r1900.
 
1 - 8 of 8 Posts
Top