T-Shirt Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Using this wonderful printer with EZ Artist and Rip program, the hard-edge borders of text and photos appear to be soft and has a visual sense of "over-spray". I suspect a software setting. Any advice from your experience ? Thanks !;)
Guys at JimiTees
 

·
Registered
Joined
·
810 Posts
Hi Hymie,

How far away is the print head from your garment? The Veloci-Jet XL has a laser height sensor that lets you automatically set the Veloci-Jet XL's print head to the optimum height above the garment.
Setting the Print Head Height on a Veloci-Jet XL
First, make sure the shirt board is underneath the laser sensor. Then press the down arrow button on the control panel. When the printer stops moving, you've set the print head at the optimum height.
If that doesn't solve the issue, there may be a software setting that needs to be changed. An Equipment Zone support technician can direct connect to your computer on Tuesday and make sure everything is set correctly.

Alex
 

·
Registered
Joined
·
7 Posts
Discussion Starter #3
Thanks Alex. That optimum height you note is in the mix for the print so I do suspect a software setting/function.
 
1 - 3 of 3 Posts
Top