T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
173 Posts
Discussion Starter · #1 ·
Hi
I have my design but don't know how to get it from coreldrawx3 to rip pro software. I sent it to the print epson2200, but it did not show up in rip software. Is there a place in corel to send it directly to rip program? If not how do you send it to the software? My cutter software is right in coreldraw I was hopong the rip software would have something along the same line. Any help would be greatly appreciated.

Thanks
April Holder
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top