T-Shirt Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
173 Posts
Discussion Starter #1
Hi
I have my design but don't know how to get it from coreldrawx3 to rip pro software. I sent it to the print epson2200, but it did not show up in rip software. Is there a place in corel to send it directly to rip program? If not how do you send it to the software? My cutter software is right in coreldraw I was hopong the rip software would have something along the same line. Any help would be greatly appreciated.

Thanks
April Holder
 

·
Banned
Joined
·
487 Posts
You go to fie>print then seect Kiosk

then you go to properties and then advanced and set you kiosk printing info!

Hope this heps!
 

·
Registered
Joined
·
52 Posts
My rip software appears in the list of available printers....when you go to print your design, look at the printers that are available to send the job to.
 

·
Registered
Joined
·
4,664 Posts
Although it is not the same named RIP, the link to this YouTube page will provide you videos on how to use the software - YouTube - Broadcast Yourself.. It is basically the same exact software from the same company with some minor changes. This should help you get a better understanding of your software.

Mark
 
1 - 4 of 4 Posts
Top