Gem Master file to Vinyl Cutter

1610 Views 9 Replies 3 Participants Last post by DivineBling, May 15, 2012

Hartz

Discussion Starter · May 14, 2012

I have a Cut3000 (GCC Bengal) and would like to get a Gem Master design file to it to cut. Is this possible and if so hoping someone out would be able to help me out with the steps to do so.

Thank you in advance

Save

1 - 10 of 10 Posts

royster13

· #2 · May 14, 2012

I am assuming you do not have the software?.....If so, you probably need to have it exported as an EPS file to get it to work...

Save

Hartz

Discussion Starter · #3 · May 14, 2012

Do you mean the cutter software or something else?

Save

DivineBling

· #4 · May 14, 2012

I might be able to help you. I'll pm you my email address.

Save

royster13

· #5 · May 14, 2012

I mean the Gem Master software so you can convert that format into something your cutter will read....

Save

Hartz

Discussion Starter · #6 · May 14, 2012

I do have Gem Master, but don't know how to do that. Shoot didn't even know that was possible.

Save

DivineBling

· #7 · May 14, 2012

Hartz said:
I do have Gem Master, but don't know how to do that. Shoot didn't even know that was possible.

I'm 99% sure that it isn't. I'll work with what you sent me and get back to you shortly!

Save

Hartz

Discussion Starter · #8 · May 14, 2012

Thank you DB

Save

royster13

· #9 · May 14, 2012

Not sure what formats it will export to....But sometimes you can cut and paste.....Worth a try.....

Save

DivineBling

· #10 · May 15, 2012

Hartz said:
Thank you DB

You're welcome.

Did you receive the file? Did it work for you?

Save

1 - 10 of 10 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month