gcc jaguar replacement blade

3734 Views 8 Replies 5 Participants Last post by dazzabling, Mar 22, 2012

CreativeInk

Discussion Starter · Mar 21, 2012

I was wondering if anyone can tell me which replacement blades to order for the gcc jaguar IV? This is my first replacement order and i'm not sure if the same blades are used as the roland cutters? Thanks.
Cilya

Save

1 - 9 of 9 Posts

rturner381

· #2 · Mar 21, 2012

CreativeInk said:
I was wondering if anyone can tell me which replacement blades to order for the gcc jaguar IV? This is my first replacement order and i'm not sure if the same blades are used as the roland cutters? Thanks.
Cilya

Cilya, you are correct, the proper replacement blade is the ROLAND. I will be happy to answer any questions you have about blades for your cutter

Save

dazzabling

· #3 · Mar 21, 2012

CreativeInk said:
I was wondering if anyone can tell me which replacement blades to order for the gcc jaguar IV? This is my first replacement order and i'm not sure if the same blades are used as the roland cutters? Thanks.
Cilya

You can check with heatpressvinyl.com 60 degree blade for all GCC cutters

this is for 60 degree I am not sure which one you need. But, you can give Roger a call about any blade you may need.

Save

charles95405

· #4 · Mar 22, 2012

Buy the clean cut blade.....so much better than OEM

Save

dazzabling

· #5 · Mar 22, 2012

charles95405 said:
Buy the clean cut blade.....so much better than OEM

I second the Clean Cut Blade, thanks Charles forgot about those.

www.cleancutblade.com they will fit in your blade holder if you have troubles locating the right one give them call them they are helpful.

Save

CreativeInk

Discussion Starter · #6 · Mar 22, 2012

Thanks very much!

Save

royster13

· #7 · Mar 22, 2012

I third Cleancut blades.....

Save

CreativeInk

Discussion Starter · #8 · Mar 22, 2012 (Edited)

but are they the same as i'd get for the roland? nm i missed a post thanks so much for the input

Save

dazzabling

· #9 · Mar 22, 2012

Nothing against OEM, but they are better, long lasting more robust and help wear and tear on your cutter. They use less downforce and have great results.

Save

1 - 9 of 9 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month