[BigCountryDesign]

Hello, I have a vinyl job to do ( the longest I have done so far) that is about 70"long. when I go cut My GCC only cuts about 48" of the decal then stops. I am cutting from Corel draw x6. has anyone ran into this problem. Any help will be greatly appreciated. Thanks, Neal

 

[into the T]

does it feel hot?

check here to see if it helps

 

[BigCountryDesign]

Thank you for your reply. no it doesn't get hot it seems to be that the cutter isn't seeing the whole design. I use CorelDraw x6 to cut with and I have now noticed that the whole design isn't showing up in the preview window before I cut. I have checked the work space and it is the proper size. Thank you for any ideas you may have...

 

[dazzabling]

Can you split up the design in 3 equal parts? I would think it would be easier for transport and application using sections rather that one big piece.

 

[BigCountryDesign]

Thanks for your reply. I can split it up but I am wanting to cut as one long decal to aid in keeping the lettering perfectly straight for installation. My GCC is an upgrade for a US Cutter 671 and I figured since my old us cutter would do it that my GCC would without any problems.

 

[hawaiianphatboy]

This maybe a stupid question, because i dont use Corel, but does it have a driver or a print option to print on a piece of paper 70" long? Does your cutter come with a cut software that would allow you to set up your workspace, and then import your image into that software? I know my cutter has an option to create a specific print size, but again i have never used Corel for my cutting. I can only assume, as with any other attached printer, if the program does not recognize the printers ability to print at such a large size, and the image is not showing completely on the screen than that is why it is not cutting properly... Good luck and Aloha

 

[mwoodrow]

Were you ever able to get this fixed? Having the same issue