T-Shirt Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Pulling our hair out. Working on an order that is due tomorrow. Using GCC expert 24 and great cut software. Logo is a 1 color using premium plus material. When we cut test cut, (25 speed with 45 blade), square cuts perfectly, but when we go to cut logo's, blade is cutting through the plastic carrier piece. Any slight adjustments we make lead to the blade not cutting 1/2 of the design. Any ideas or suggestions out there? p.s. I do not have an extra 45 blade, although this one has been barely used. I do have a 60 degree blade that is also in good shape, if needed?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top