T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
I have been running my GCC Expert 24 with no problems when suddenly it seems to have a mind of its own. I turned it on this am and it keeps running uo and down the track without letting me set origin or take on or off line. I have turned off and back on again and checked settings. It jusr keeps running. SHould I reinstall the driver?
 

· Registered
Joined
·
1,882 Posts
I have been running my GCC Expert 24 with no problems when suddenly it seems to have a mind of its own. I turned it on this am and it keeps running uo and down the track without letting me set origin or take on or off line. I have turned off and back on again and checked settings. It jusr keeps running. SHould I reinstall the driver?
Check the position of your pinch rollers. If they are too close together this will happen.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top