T-Shirt Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
47 Posts
Discussion Starter · #1 ·
I was cutting a template and realized I had not changed to 2 passes, I pressed stop cutting and the cutter would not stop. I tried just shutting off cutter and when I started up again it just continues cutting. How do you stop a design from cutting?
Second Question-The cutter cuts great but the green error light is always flashing. Any suggestions as to why? Thank you for your help.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top