T-Shirt Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
Has anyone worked with GCC Expert 24 vinyl cutter to create rhinestone stencils? Any feedback would be helpful. I'm trying to find a rhinestone stencil solution for under $600.
 

·
Registered
Joined
·
1,959 Posts
While I believe the GCC Expert 24 is capable of cutting Rhinestone Templates, it is powered by a Stepper motor. This motor type cannot withstand the abuse that cutting through the Rhinestone Templates will cause.

If you are looking to primarly do this, then you need to look for a cutter that has a Servo motor.

The GCC Bengal is identical to the Expert 24 and has a Servo motor. It is more expensive though. I have seen them at around $750.
 

·
Registered
Joined
·
996 Posts
Nick...what type motor does the Graphtec 5000-60 have?
 
1 - 4 of 4 Posts
Top