T-Shirt Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 ·
I am new to this forum and found the advice from experts very helpful.

I have a GCC cutter (Jaguar IV) with a Roland Blade. Cutter is not cutting the vinyl thoroughly so much so that when weeding some of the letters come off.

Do you have a advice on what settings are best for blade depth?
 

·
Registered
Joined
·
1,352 Posts
I don't have a jaguar but for the blade depth "the rule of thumb" is to don't let it stick out longer than the thickness of a credit card. Set the blade depth first and then move on to settings. Hope this helps.
 

·
Registered
Joined
·
242 Posts
I don't have a jaguar but for the blade depth "the rule of thumb" is to don't let it stick out longer than the thickness of a credit card. Set the blade depth first and then move on to settings. Hope this helps.
Actually depends on the material you are cutting. Some material is thicker/thinner and will need to adjust the blade depth slightly.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top