did you print to the edge from flexi? if you did and applied the contour cut before you printed, then you should be able to set your GS15 up in the flexi production manager and cut. i'm working from memory because it's been a long time since i used an edge setup, but you may have to also include the 'target' mark on the print to properly align the GS15.
Flex 7.0 pro
Im using Flexi 7.0 PRO and I figured out how to do the contour outline cutting. I had printed out
something on the Edge and then wanted to do the contour cut with the (GS15 PLUS) around that
item. Is there a way to do that? I was playing a "guessing" game trying to
figure out how to contour cut around the printed graphic with measurements,
but I was always a bit off. Any help on this would be great. I didn't see
anything in the help menu on this.
Thanks,
Matt
something on the Edge and then wanted to do the contour cut with the (GS15 PLUS) around that
item. Is there a way to do that? I was playing a "guessing" game trying to
figure out how to contour cut around the printed graphic with measurements,
but I was always a bit off. Any help on this would be great. I didn't see
anything in the help menu on this.
Thanks,
Matt
1 - 2 of 2 Posts
1 - 2 of 2 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
T-Shirt Forums
A forum community dedicated to T-shirt merchants, professionals and enthusiasts. Come join the discussion about graphics, commerce, dyes, prints, collections, guides, displays, styles, scales, equipment, accessories, reviews, classifieds, and more!
Full Forum Listing
Recommended Communities
