T-Shirt Forums banner
1 - 3 of 3 Posts

· Registered
21 Posts
Discussion Starter · #1 ·
Hi all,

I have a 3x6 cap press by tgt which recently started smoking above the platen. I took it apart and the wires and wire shields look melted. One of the screws which attach the wire to the platen is rusted and immediately broke as well. I figured that instead of fixing the platen, that i would try to convert it to a flat platen so I can use it for above the heart transfers for tshirts.

I would also like to replace the wire with a thicker gauge as well as the shielding (teflon?).

Does anyone know where i can purchase a small flat platen and base to convert it? where can I get the shielding for the wire as well? Its a tgt press, but i cannot find it anywhere online.

1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.