T-Shirt Forums banner
1 - 3 of 3 Posts

44 Posts
Yikes.. talk about bad timing. I say do a test print. You will likely have to hit, flash hit again and see how it looks.. Hold that last flash and keep count of the time its in there... the take the garment and rub the ink side on another test piece. If it comes off.. its not cured. Try again for longer periods until you come up with the right time.

If possible you might go high density... very minimally but it might help to hold the ink and keep it from bleeding.

Hope this helps, good luck.

Rj Dollen
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.