T-Shirt Forums banner
1 - 2 of 2 Posts

· Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
Hi! I have started making tshirts using ink jet transfer paper and have a few questions (I'm very new to this so sorry if it's all a bit obvious!).
So far I have just been using a standard iron and have only had one person say that the design flaked off - is there an advantage to getting a heat press in terms of quality, or is it just easier because it's quicker? Obviously if using an iron is really bad quality, I don't want to continue.
Also, I have been just doing designs in square/rectangles etc, then cutting them out - I've noticed other people have designs made with heat transfers that are intricate shapes, with bits cut out etc...how is that done?
Any advice/tips for this very novice tshirt designer would be gratefully recieved!!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top