T-Shirt Forums banner
1 - 1 of 1 Posts

4 Posts
Discussion Starter · #1 ·
Hello I’ve been trying to print my first t shirt on a VELOCI JET XL using the latest EZ RIP software and after the job is spooled and holding to print, I press print and it won’t pass 10%. The printer won’t even move until I abort the job. Am I having connection issues? Is my print head bad?

also I have a steady red error light for ink, I believe the magenta is low. Will this stop it from doing a basic print?

I’m just trying to test this thing out to make sure I wasn’t robbed for my 4K 😩😩😩😩😩😩
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.