T-Shirt Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
Ive had my cutter for a few years and got a job doing a 15 ft banner.I try to cut it at like 22 inches x60" and im using a 24"oracal vinyl and it keeps showing up 1 error saying it doesnt fit on the media so i go to layout and hit fit to page then it shrinks it to like 15 inches.then if i do it the other way.I get the paper size from printer then go to page set up then it goes to 23.6 height by 46 width for some reason.Im using coreldraw 4 any answers would be appreciated :(
thanks,Gary
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top