T-Shirt Forums banner
1 - 1 of 1 Posts

·
Registered
Gildan
Joined
·
41 Posts
Discussion Starter · #1 ·
Hello,
when we power on our Spectra 3000 we get a flashing error 0AH. Capping station doesn't go down and doesn't let go of the printhead to move to the left. We get the loud screeching noise from there and get an error.
When we lower the capping station before powering on, the printer turns on fine, finds the position, CR moves to the left. Then, when it goes back to the capping station and the print head attaches and then doesn't let go and we get a 51H error with loud screeching noise again.
So, basically whenever the printhead attaches to the capping station, the capping station then doesn't go down and doesn't release the printhead. We changed cap stations and get the same outcome.
Any suggestions??? Thank you so much in advance.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top