• 0001001D - CR servo parameter error
http://www.t-shirtforums.com/neoflex/t258497-2.html
This code has come up on me several times. 9 out of 10 it has to do with the sensor near the end of the encoder strip (capping station side). It is located above the belt gear and sometimes can be bumped out of place when removing or replacing the belt. I would check that area first. Check your encoder strip too.
Found that the plastic arm that controls and moves the wiper blade had come off so the wiper blade was just staying under the print head simply just clipped it back in done a couple of simple cleans and all good working fine again.
And/or
Check the sensor that is located near the belt gear. Look near the end of the encoder strip where the carriage sits. You will need to release the carriage to access the sensor. Sometimes it can get bumped when removing/installing the belt and become misaligned causing
this error code.
Usually if I get that error code it was because the carriage sensor was misaligned. If you move the print carriage away from the capping station you will see a small sensor near the belt gear - look near the encoder strip. Verify that it is “snapped” into the machine completely and see if that fixes your issue.
http://www.t-shirtforums.com/neoflex/t258497-2.html
This code has come up on me several times. 9 out of 10 it has to do with the sensor near the end of the encoder strip (capping station side). It is located above the belt gear and sometimes can be bumped out of place when removing or replacing the belt. I would check that area first. Check your encoder strip too.
Found that the plastic arm that controls and moves the wiper blade had come off so the wiper blade was just staying under the print head simply just clipped it back in done a couple of simple cleans and all good working fine again.
And/or
Check the sensor that is located near the belt gear. Look near the end of the encoder strip where the carriage sits. You will need to release the carriage to access the sensor. Sometimes it can get bumped when removing/installing the belt and become misaligned causing
this error code.
Usually if I get that error code it was because the carriage sensor was misaligned. If you move the print carriage away from the capping station you will see a small sensor near the belt gear - look near the encoder strip. Verify that it is “snapped” into the machine completely and see if that fixes your issue.
