T-Shirt Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
389 Posts
Discussion Starter · #1 ·
I'm trying to set up my epson 1400 for 13"x18" R-film

It doesn't have a setting for that size. The closet is 13x19

Under user defined, one dimension can go as high as 44", but for width you can only go to 12.95

Anyone else use the 13"x18" r-film with this printer?

Also, I downloaded ghostscript. How are you supposed to use it. I can't find directions for it anywhere. I just get a command prompt.
 

·
Registered
Joined
·
108 Posts
Also having the same issue. Was able to make a user defined 13x18 setting, but it doesn't seem to let you use borderless...

1) Can you keep transparencies in register using the 13x19 setting? Does it just start at the top edge or does it center the extra vertical inch that is lost?
2) Does anyone know if borderless is ok to use? Or does "borderless" cause problems?

thanks!
 
1 - 4 of 4 Posts
Top